ACANII - Black Housing LED DRL Tube Projector Headlights for 2007-2014 Toyota FJ Cruiser - High Performance Replacement Headlamps (Driver & Passenger Side) - Perfect for Off-Roading, Night Driving & Custom Car Upgrades

I purchased this headlight assembly about 2 years ago. They still work great.They look great, fit well, and are very easy to install. They definitely need to be adjusted after install. Please do not just install these headlights and then go for a night drive. You will blind everyone on the road and not be able to see very well. There are two adjustment "screws" on the back of the light that you turn to adjust the angle.With that, installation is easy, the same way your headlight comes out is the same way your new headlights go in.These headlights are plug and play. The only part of the light that is not is the LED "ring." Those require you to wire them in. I supplied two photos of how I mocked the lights to turn on with the running lights:Parts used to wire LED "ring":"Nilight - 50004R"https://a.co/d/8R5EVx1"WORKPRO 6” Slip Joint Pliers Tool" https://a.co/d/hcRWTjG"haisstronica Self-Adjusting Wire Stripper"https://a.co/d/4ENIlfHThe BLUE wire (2007 FJ cruiser) or top wire on the headlight plug is going to be your headlight control/running light. I wired mine directly into that BLUE wire using a crimp clamp. This will turn on the LED when the running lights or headlights are activated. You can achieve this method by taking the GREEN wire from the HEADLIGHT and splicing it to the BLUE wire on your headlight plug.You can also splice these into the turn signal/marker lights by splicing them onto the GREEN wire on your turn signal/marker light plug. So that way they only turn on when you have your marker lights on, or when you are using your headlights directly via the headlight switch. (I do not have pictures of that wire.)You can also wire them direct to power using a wire that has constant power when the ignition is on. That will be one of the RED wires at your headlight plug. You can figure out which one that is by using a volt meter and turning the ignition on to see which wire has power when the ignition is on whether the headlights are on or off.The BLACK wire attached to the headlight is going to be ground. Splice that wire into the ground wires (also BLACK) on your headlight plug. You can also take the BLACK wires and ground them directly to the vehicle chassis as long as its bare metal to metal.Good luck, have fun.Disclaimer: I'm not responsible if you die, or if you burn your vehicle down, or if you break the headlight, or your factory harness, or you blow up your vehicle, or if your family member gets cancer.Again, good luck, have fun.